In the process of concrete batching plant, the amount of water used directly affects the strength of concrete. The problem of water over the crack, honeycomb and pits caused by it will reduce the durability of concrete. As is known to all, reducing the water consumption can increase the strength and durability of concrete and save some cost, so it should be strictly controlled in the process of production. So, how to control the concrete batching plant with water?

First of all, we should strictly control the performance of each material to control the above factors to reduce water consumption. By using high content of cementitious materials to improve and ease of. Multi detection sand moisture content, enhance the sense of responsibility, to ensure that each output of the concrete slump in the control range.

Secondly, by increasing the amount of admixture or the use of high efficiency and high water reduction rate of admixture, select the better adaptability of admixture and cement varieties. Improve the sand gradation, identify each mix the best sand gradation to improve workability, thereby reducing water consumption.

Finally, with the concrete batching plant construction site. It is very important to communicate, to get the construction personnel with more understanding, avoid the slump is too large and technical personnel construction. Correct understanding: not slump is bigger, pumping will more easily, and should be adjusted and easy to adjust the amount of gravel and.

Usually the concrete batching plant when the actual production of water and water will be equipped with great difference. Therefore, in strict accordance with the content of the test selection is better than or close to the material, the more stringent water binder ratio control, to ensure that there is sufficient surplus strength, and then to ensure the final entry site is also qualified.