Rationally use dust collector of concrete batching plant
In the field case, even though dust collector is used in most of concrete batching plants, the effect is still not good.Some are after installed the dust removal equipment, the weight accuracy of the power is affected by the negative pressure of weighing bucket.So, it's essential to use rationally the dust collector of concrete batching plant. In the field of concrete batching plant, some users directly connect the air guide duct of the concrete mixer to the lower part of the dust collector to save the cost. However, owing to the suction of the wind machine,dust blown by pulse can't set to the bottom and flow to the host, making the filter element is always in the dust. Because of the process of the dust, the working efficiency of the dust collector is greatly reduced. The user can install a butterfly valve at the bottom of the dust hopper. Close the butterfly valve when filter works. And all of the air pipe are connected to the flange of the side of dust hopper. Provide a space for the settlement of dust blown pulse and avoid to cause the second-pollution. In the site of concrete batching plant, the user can regular open valve and clean out the collected dust per fiver hours, then let collected dust into concrete mixer to reduce labor intensity of dust collector. So, in the course of concrete batching working,reasonable application of dedusting equipment can avoid dust pollution and realize the call of building green concrete batching plant. At the same time, it can also greatly improve the overall performance of concrete batching plant.
Your position: 
