Concrete Mixer Operate Steps:
1, the column on the function switch, dial to "automatic" position, press the controller on the start switch, the entire running program will automatically control their own operation.
2, after the completion of the whole process automatically stops running in the project for the half-way stop, you can press the stop button and then restart.
3, press the start button, the display began to show the time, slow, sand, fast, stop, fast, running lights flash on time.
4, automatic control, the manual function must be all the switches to the stop position.
Operation Note:
1, with the measuring gauge to detect the gap between the blade and the pot wall should be 3mm ± 2mm, if the gap is poor, you can adjust the upper and lower blade position to reach the specified range.
2, after each use of the mixing leaves, the pot should be promptly cleaned up, electrical parts should avoid severe vibration, away from water and heat, pay attention to dust.

Cleaning Precautions:
In the concrete mixer for cleaning should pay attention to the following:
1 regular maintenance procedures required by the maintenance of the project, maintenance operations, such as cleaning, lubrication, fuel, etc.
2 concrete mixer before starting to check whether the controller is good, shut down after the water and stone into the mixing tube 10 to 15 minutes for cleaning, and then clear water and stones. If the operator has to enter the mixing tank cleaning, in addition to cut off the power and remove the fuse, and lock the switch box.
3 to prohibit the use of sledge hammer knock method to remove concrete accumulated in the concrete mixer tube, can only be removed with a chisel.
4 in the cold season, after the completion of the application of water cleaning mixer drum and pump, water tanks, water pipes within the net release, so as to avoid water pumps, water tanks, water pipes and other freezing damage.